събота, 22 ноември 2014 г.

Simple Tom Tuning Guidelines: Understanding How To Achieve The Most Excellent Sound for Your Set-Up's Toms

By Victor Salazar














Tuning tom toms often baffles many drummers. It could be because, for the most part, drummers do not tune them to specific notes. There are, of course, some exceptions - like the great Terry Bozzio, who tunes the 31 toms on his enormous kit both chromatically and diatonically. The other aspect that can make tuning toms a bit more tricky than tuning a snare drum or bass drum is that toms produce many more overtones. These additional overtones can sometimes make it difficult to focus on the true pitch of the drum.

So then how are we supposed to tune our toms if we are not tuning them to specific notes and we have to deal with the complexity of their overtones? I would like to present some fundamental tuning guidelines that can assist any drummer achieve the desired tone and sound from their toms.

Don't Tune Your Toms While They Are Set Up

Most drummers understand the basic rule of tuning - tap along the perimeter of the drum near each tension rod, choose a pitch, and tune each tension rod to attain the same pitch all the way around. The error most drummers make, however, is that they attempt to tune the toms while they are set up. The problem with this method is that you are hearing both heads resonating fully as you tap, and can't accurately hear the specific pitch that you're trying to attain.

The first step that I always suggest when tuning your toms is to take them off of their stands or mounts and put them on a soft surface (like a drum throne), one at a time. This applies to floor toms as well. When you do this, you are now only hearing one head at a time, which makes it much simpler to determine the true pitch of your toms/drum.

Relationship Between the Heads

Unless you are using a single headed concert tom, your toms consist of two heads. The relationship between the two heads plays a significant role in their sound. Generally, the bottom or resonant head should be tuned slightly higher than the batter side or the head that you strike. The batter head gives you the desired pitch and the resonant head helps the drum to hold that pitch. If the resonant head is tuned too low, you may get a funny pitch bend that descends. Alternately, if the bottom head is tuned too high you'll get the opposite effect with a pitch bending upward.

When evaluating the relationship between the heads, I like to lay the drum on its side on a soft surface (like a drum throne) to preserve the finish. Then, I mute one head with one hand while striking the opposite head with my other hand. By muting one head while tapping the other, I can clearly hear the pitch of each head since I'm only focusing on one head at a time. If I determine that the relationship between the two heads is off, but I know that the drum is in tune in terms of equal tension on all of the rods, I can quickly raise or lower the pitch of both heads by systematically turning each tension rod an equal number of turns either clockwise or counterclockwise.

I hope these basic tips help you tune your toms more consistently and efficiently. Just remember to be patient and take your time. Your tuning skills will develop over time to the point where it becomes second nature.

Good luck!




About the Author:



Няма коментари:

Публикуване на коментар